When cutting out the main parts, I had not finished cutting all of the smaller pieces that were laid out inside cutouts from the side panels.
First I cut out the two rectangular pieces from the rear panel.
This allowed me to cut this set of small pieces for the handle channel, as well as the base of the bottom drawer.
Next I made use of the PDF supplied with the plans for the curved shapes on the side panels.
The same PDF was used for the side panel strengthening overlays.
One of the cutouts from the side panel was used for drawing the hooks for keeping the table top in place when it is lowered.
These were cut out on the band saw and will be sanded to shape later.
