The various goings on in my workshop
Some time back I purchased a Bosch GTS 10 XC 10″ table saw with Bosch GTA60W folding table from Ebay for the bargain price of £240.00. The table saw alone sells for around £550.00 new and the folding stand for around £185.00, so this was an absolute bargain, and the seller even delivered it to…
This will probably be the last post on the MF-TC build, covering the last few bits that still needed to be done. I rounded off the ends of the handle sides and cut a section of broom handle to length before screwing it in from both ends. Handle in its lowered position. The lengths of…
The drawer fronts were all shaped on the bandsaw. The drawer bases had their holes, for holding the Systainer feet, cut out using a drill for an initial hole and then finished off using a pattern bit in the router, I made a couple of mini templates that I stuck to the first base and…
For the worktop I gave a sheet of moisture resistant MDF a couple of coats of varnish on both sides, to try and prevent warping, plus it means that I don’t need to worry about which way up I install it each time, before cutting out a worktop rectangle. First I drew out a 90…